Application of UG Software in Mechanical Design

Authors

  • Shuochun Feng Equipment Development Department of Tianjin China Electronic Technology Group Corporation Forty-sixth Research Institute

DOI:

https://doi.org/10.30564/frae.v1i1.9

Abstract

UG software is powerful, and has been widely applied in machine design. The following is an analysis of the development of UG software. It also analyzes the characteristics of use and analyzes the specific application, hoping to give some references to the people concerned.

Keywords:

UG software, Mechanical design, Practical application

References

[1] The auxiliary application of UG software in the teaching of mechanical drawing[J]. Journal of Harbin Vocational and Technical College, 2016 (2): 51-53. (in Chinese)

[2] Nan Li. UG software in the mechanical design of the application and research[J]. China Equipment Engineering, 2016 (11): 130-130. (in Chinese)

[3] Ni Hua Zheng. On the application of 3D modeling software in mechanical design -UG to the strength design of parts[J]. Chinese machinery, 2014 (13): 237-238. (in Chinese)

Downloads

Issue

Vol. 1 , Iss. 1 (January 2018)

Article Type

Building Implementation

License

Copyright and Licensing

The authors shall retain the copyright of their work but allow the Publisher to publish, copy, distribute, and convey the work.

Frontiers Research of Architecture and Engineering publishes accepted manuscripts under Creative Commons Attribution-NonCommercial 4.0 International License (CC BY-NC 4.0). Authors who submit their papers for publication by Frontiers Research of Architecture and Engineering agree to have the CC BY-NC 4.0 license applied to their work, and that anyone is allowed to reuse the article or part of it free of charge for non-commercial use. As long as you follow the license terms and original source is properly cited, anyone may copy, redistribute the material in any medium or format, remix, transform, and build upon the material.

License Policy for Reuse of Third-Party Materials

If a manuscript submitted to the journal contains the materials which are held in copyright by a third-party, authors are responsible for obtaining permissions from the copyright holder to reuse or republish any previously published figures, illustrations, charts, tables, photographs, and text excerpts, etc. When submitting a manuscript, official written proof of permission must be provided and clearly stated in the cover letter.
The editorial office of the journal has the right to reject/retract articles that reuse third-party materials without permission.

Journal Policies on Data Sharing

We encourage authors to share articles published in our journal to other data platforms, but only if it is noted that it has been published in this journal.