Experimental Shear Study on Reinforced High Strength Concrete Beams Made Using Blended Cement

Authors

  • Brijesh Singh National Council for Cement and Building Materials, Ballabgarh, Haryana, India
  • VIKAS PATEL National Council for Cement and Building Materials, Ballabgarh, Haryana, India
  • P. N. Ojha National Council for Cement and Building Materials, Ballabgarh, Haryana, India
  • Amit Trivedi National Council for Cement and Building Materials, Ballabgarh, Haryana, India
  • V V Arora National Council for Cement and Building Materials

DOI:

https://doi.org/10.30564/jaeser.v5i1.4064

Abstract

With the increased application of High Strength Concrete (HSC) inconstruction and lack of proper guidelines for structural design in India,behavioral study of high strength concrete is an important aspect ofresearch. Research on the behavior of HSC reinforced beams with concretestrength more than 60 MPa has been carried out in the past and is stillcontinuing to understand the structural behavior of HSC beams. Along withthe many benefits of the high strength concrete, the more brittle behavior isof concern which leads to sudden failure. This paper presents the behaviorof reinforced HSC beams in shear with considering the effects of variousfactors like shear reinforcement ratio, longitudinal reinforcement ratio, l/dratio (length to depth ratio), etc. Ten numbers Reinforced Concrete Beamsof various sizes using concrete mix with three different w/c ratios (0.46, 0.26and 0.21) were cast for shear strength assessment. The beams were tested insimply supported condition over two fixed steel pedestals with load rate of0.2 mm/minute in displacement control. Mid-point deflection was measuredusing LVDT. A comparative analysis of theoretical approaches of Eurocode, extension of current IS code up to M90 and the experimental datawas done to understand the behavior of beams. Shear capacities of beamswithout any factors of safety were used to assess the actual capacities andthen was compared with the experimental capacity obtained. Results ofthis study can be used in the design of high strength concrete and will bemore reliable in Indian continent as the regional materials and exposureconditions were considered.

Keywords:

High strength concrete, Shear capacity, Reinforced concrete beams, Shear behaviour, Span to depth ratio

References

[1] Arora, V.V., Singh, B., Jain, S., January 2017. Effect of indigenous aggregate type on mechanical properties of high strength concrete. Indian Concrete Journal. 91(1), 34-44.

[2] Arora, V.V., Singh, B., Jain, S., October 2016. Indian “Experimental studies on short term mechanical properties of high strength concrete” Concrete Journal. 90(10), 65-75.

[3] Arora, V.V., Singh, B., Patel, V., July 2018. Study on flexural behaviour of reinforced high strength concrete beams. Indian Concrete Journal. 92(7).

[4] Cetin, A., Carrasquillo, R.L., 1998. High-Performance Concrete: Influence of Coarse Aggregates on Mechanical Properties, Journal of ACI Materials. 95, 252-261.

[5] Cladera Bohigas, Antoni. Shear design of reinforced high-strength concrete beams, doctoral thesis. https://www.researchgate.net/publication/263696608_Shear_design_of_reinforced_high-strength_concrete_beams

[6] Piyamahant, 2002. Shear behavior of reinforced concrete beams with small amount of web reinforcement, M. Eng. Dissertation, Kochi University of Technology, Japan.

[7] Lesley, H., Sneed, Julio, A., 2008. Effect of Depth on the Shear Strength of Concrete Beams without Shear Reinforcement, USA Portland and cement Association. http://www.cement.org/exec2/11-03-08.htm.

[8] Reineck, K.H., Kuchma, D., Kim, K.A., Marx, S., 2003. Shear database for reinforced concrete members without shear reinforcement. ACI Struct. 100(2).

[9] Bazant, Z.P., Kazemi, M.T., 1991. Size effect on diagonal shear failure of beams without stirrups. ACI Structural Journal. 88(3), 268-276.

[10] Tan, K.H., Lu, H.Y., 1999. Shear behaviour of large reinforced concrete deep beams and code comparisons, ACI Structural Journal. 96(5), 836-845.

[11] Walraven, J., Lehwalter, N., 1994. Size effects in short beams loaded in shear. ACI Struct. Journal. 91(5), 585-593.

[12] Chana, P.S., 1987. Investigation of the mechanism of shear failure of reinforced concrete beams, Magazine of Concrete Research. 39(141), 196-204.

[13] Collins, M.P., Kuchma, D., 1999. How safe are our large, lightly reinforced concrete beams, slabs and footings. ACI Structural Journal. 96(4), 482-490.

[14] IS: 456-2000. Code of Practice for Plain and Reinforced Concrete. Bureau of Indian Standards, New Delhi.

[15] ACI: 318-1989. Building Code Requirements for Structural Concrete. American Concrete Institute.

[16] ACI: 318-1995. Building Code Requirements for Structural Concrete. American Concrete Institute.

[17] ACI: 318-2014. Building Code Requirements for Structural Concrete. American Concrete Institute.

[18] IS: 383-2016. Coarse and fine aggregate for Concrete-Specification. Bureau of Indian Standards, New Delhi.

[19] CPWD-2009. Central Public Works Department Manual, Government of India.

[20] IS: 1727-1967. Methods of Test for Pozzolanic Materials. Bureau of Indian Standards, New Delhi.

[21] ACI Committee 211.1-1991. Standard Practice for Selecting Proportions for Normal, Heavyweight and Mass Concrete. American Concrete Institute, Detroit.

[22] IS: 516-2018. Hardened concrete-method of tests. Bureau of Indian Standards, New Delhi.

[23] ACI Committee 363R-2010. Report on High Strength Concrete. American Concrete Institute.

[24] Eurocode 2-2004. Design of concrete structures, European Committee for Standardization.

Downloads

How to Cite

Singh, B., PATEL, V., Ojha, P. N., Trivedi, A., & Arora, V. V. (2022). Experimental Shear Study on Reinforced High Strength Concrete Beams Made Using Blended Cement. Journal of Architectural Environment & Structural Engineering Research, 5(1), 9–16. https://doi.org/10.30564/jaeser.v5i1.4064

Issue

Article Type

Article